Dle 170 Manual do Utilizador

1DLE-170Specifications170cc [10.37 cu. in.]17.5 HP/ 9,000 RPM1,10 0 R P MElectronic Ignition 30u12, 32u10CM6(Gap) 0.018in.– 0.020 in. [0.45 mm –

108. Connect the ignition wires from ignition module to the spark plugs.9. Install the muffl ers onto the engine with the included gaskets. Tighten the

115. Mark the location of one of the outer holes on the propeller. Use a GPM Dead Center Hole Locator (GPMR8130) to center and start the hole.6. Remo

12Idle AdjustmentTurning the Idle Adjustment Screw (No.3) clockwise will increase the idle speed. Turning the Idle Screw counter-clockwise will decrea

13Problem: If The idle is not steady.Solution:The low-speed needle “L” valve is too rich. Close it 1/8 of a turn and try again.Problem: If Engine

14 6. Move the choke lever to the OPEN position. 7. Set the throttle to a high idle. Set the propeller so that it is near the beginning of the comp

15Symptom Diagnosis FixEnginedoes notfireIgnition battery low Charge or replace batteryEngine starts,then rpmincreases tillengine cuts outFuel not rea

16Engine MaintenancePlease clean the fuel fi lter in the DLE Carburetor periodically. Failure to do so may result in miss-calibration of the needle adj

17Warranty InformationThe DLE-170 has a two year limited warranty through Hobby Services beginning at date of purchase. Please retain your receipt as

18296321010202324123131918172224202345251317201322045251317301526933112716288321

19Key Numbers #1 Cylinder #2 Crankshaft w/Rods #3 Crankcase #4 Piston #5 Ring #6 Electronic Ignition System #7 Left Muffl er (one external m

2Parts List (1) DLE-170cc Gas Engine w/ DLE carburetor (2) DLE (CM-6 size) Spark plugs(2) Muffl ers w/(2) gaskets(4) 5x20mm SHCS (muffl er mounting)(1)

DLE-170 Mounting Pattern3.15 in.[80 mm]3.54 in.90 mm

3absorber. Otherwise it is probable that vibration could rebound back to the engine and serious damages may occur during the break-in period.● For y

4● For optimum performance please use fresh or recently purchased 87 octane gasoline with a 30:1 gas/oil mixture.GAS/OIL Mixing Guide1 Gallon Gasoli

5● To avoid permanent damage to the electronic ignition system, NEVER rotate the propeller on your DLE engine with the electronic ignition system sw

63. Connect the ignition kill switch lead to the red connector from the ignition control module using the lead from the kill switch or with the includ

7Ignition Wires(To Spark Plugs)Ignition ControlSwitch Wire(To On/Off Switch)Pick-UpSensor Wire(To Sensor On Engine)TachometerLead/RPMSignalOut-PutELEC

8Installing the DLE-170 on Your AirplaneNote: The DLE-170 must be installed on at least a 3/8" [9.5mm] fi rewall. The fi rewall must be securely gl

9One line should go to the carburetor via a gasoline approved T- fi tting and the other is to be used as a vent (a vent line is simply an open ended fu